Monel K-500

Short Description:


Product Detail

HOW TO USE THE SAWBLADE

Product Tags

Description

MONEL alloy K-500 (UNS N05500 / W. Nr. 2.4375) is a nickel-copper alloy which combines the excellent corrosion resistance of MONEL alloy 400 with the added advantages of greater strength and hardness. The increased properties are obtained by adding aluminum and titanium to the nickel-copper base, and by heating under controlled conditions so that submicroscopic particles of Ni3 (Ti, Al) are precipitated throughout the matrix. The thermal processing used to effect precipitation is commonly called age hardening or aging. Typical applications for MONEL K-500 products are chains and cables, fasteners and springs for marine service; pump and valve components for chemical processing; doctor blades and scrapers for pulp processing in paper production; oil well drill collars and instruments, pump shafts and impellers, non-magnetic housings, safety lifts and valves for oil and gas production; and sensors and other electronic components.

Limiting Chemical Composition, %

Nickel (plus Cobalt)  63.0 min.
Carbon  0.25 max.
Manganese  1.5 max.
Iron  2.0 max.
Sulfur  0.01 max.
Silicon  0.5 max.
Copper  27.0 - 33.0
Aluminum  2.30 - 3.15
Titanium  0.35 - 0.85

Application

Sour-gas service applications

Oil and gas production safety lifts and valves

Oil-well tools and instruments like drill collars

Oil well industry

Doctor blades and scrapers

Chains, cables, springs, valve trim, fasteners for marine service

Pump shafts and impellers in marine service

Equal Grade

UNS N05500, Alloy K500

Forms of Monel K-500 available

Plate, strip, bar, wire, pipe, forging, flange, fastener


  • Previous:
  • Next:

  • The use and maintain of the sawblade

    ◎ The carbide tip of sawblade is very sharp, so process of using must be prevent the carbide tip.

    ◎ PeriodicaI cleaning and support the machine,the spindle’s running tolerance must be less than h7.

    ◎ The flanges must be parallel to each other,must be of the same diameter 1/3 of the sawblade’s diameter(formuIti—rip saw blade is 1/2.

    ◎ When instaIIion the sawbIade,it shaII be 5-6 teeth higher than board surface.

    ◎ Before operation,check the firmly of the sawblade,be sure nobody in front of the machine. Do not feed of operation check whether the machine is good for operaiton. Periodical check the function of the machine,the certicaI jump is less than ±0.02MM,and the flap is less than ±0.01.

    ◎ After continuous use,must be removed and cleaning the sawblade,get rid of the resin and sawdust of the sawblade of both sides.Other wise it would beinfluence the effect of using the sawblade.

    ◎ Deposit of the sawblade,must not be layer the sawblade,it is putted in the originaI package inside.

    The renovate of the sawbIade

    ◎ The renovate of the carbide sawblade While it no longer sharpen and the horizontaI piece coarseaess. The power of using sawblade machine obviously Increase. When process materiaI,the materiaI appearred burst. The carbide tip exhaust more than 0.02MM.

    ◎ For the renovate the sawblade,it shouId be grinding by the a formal company, so be sure the quality of the sawblade after renovating.